Specified Standards; Safety; Safety Instructions - Festo CMMT-AS-C2-3A Series Assembly And Installation Manual

Safety

Warnings on the product
The following warnings are attached to the right side of the device:
Warnings on the product (en, fr)
CAUTION
Risk of Electric Shock! Do not touch electrical connectors for
5 minutes after switching power off! Read manual before
installing! High leakage current! First connect to earth!
ATTENTION
Risque de décharge électrique! Après la mise hors tension, ne pas
toucher les connecteurs électriques pendant au moins 5 minutes!
Lire le manuel avant installation! Courant de défaut élevé! Relier
tout d´abord à la terre!
DANGER
Risk of Electric Shock! Disconnect power and wait 5 minutes
before servicing.
Risque de décharge électrique! Débranchez l'alimentation et
attendez 5 min. avant de procéder à l'entretien.
Tab. 7 Warnings on the product
1.5

Specified standards

Version
IEC 61800-5-1:2016
EN 61800-3:2004+A1:2012
EN 61800-5-2:2017
EN 61800-2:2015
Tab. 8 Standards specified in the document
2 Safety
2.1

Safety instructions

General safety instructions
– Assembly and installation should only be carried out by qualified personnel.
– Only use the product if it is in perfect technical condition.
– Only use the product in original status without unauthorised modifications.
– Do not carry out repairs on the product. If defective, replace the device immediately.
– Observe labelling on the product.
– Take into consideration the ambient conditions at the location of use.
The safety functions might fail and malfunctions might occur if you do not comply with the para-
meters and conditions required for the surroundings and connections.
Festo — CMMT-AS-C2/C4-3A-... — 2018-02
Meaning
VORSICHT
Gefahr des elektrischen Sch-
lags! Berühren Sie keine
elektrischen Anschlüsse inner-
halb 5 Minuten nach dem Aus-
schalten! Lesen Sie das Hand-
buch vor der Installation! Hoher
Ableitstrom nach PE! Gerät
zuerst mit PE verbinden!
Gefahr
Gefahr des elektrischen Sch-
lags! Vor dem Durchführen von
Wartungsarbeiten die Stromver-
sorgung trennen und 5 Minuten
warten.
EN 60204-1:2006+A1:2009+AC:2010
EN 61131-2:2007
IEC 60364-1:2005
–
9