Alaxala AX1250S Series Manual page 32

AX1240S-AP-0202C_R2X
2.3.9 Event location = DHCPSN [Addition]
The following message has been added to No. 15 in Table 2-24 Switch INFO information when the event location is
DHCPSN.
Table 2-24 Switch INFO information when the event location is DHCPSN
No. Event Event
level location
15 INFO DHCPSN
An invalid DHCP server was detected. This message is output once every 5 minutes on a port-by-port basis.
<IF_number>: Type and number of the interface that received the DHCP packets
・
<IF#>: Interface port number
・
ChGr: <channel-group#>: Channel group number
<VLAN ID>/<MAC_address>/<IP_address>: DHCP server information
<VLAN ID>: VLAN ID
<MAC_address>: MAC address
<IP_address>: IP address
[Action]
Check the connected device.
2.5 Port
2.5.3 Event location = FABRIC [Addition]
The following message has been added to No. 6 in Table 2-55 Switch CRITC information when the event location is
FABRIC.
Table 2-55 Switch CRITC information when the event location is FABRIC
No. Event Event
level location
6 CRITC FABRIC
Configuration for the hardware failed.
<STG#>: Used for analysis by the manufacturer
<xx>: Used for analysis by the manufacturer
[Action]
Restart the Switch by executing the
Ref. Code
DHCP server packets were received at an untrust
port(<IF_number>/<VLAN-ID>/<MAC_address>/<IP_address>).
Ref. Code
1d290000
Failed to set STG
operation command, or by turning it off and then on.
reload
Message text
Description
Message text
Description
<STG#>
(rv=<xx>)
32