Alaxala AX1250S Series Manual page 18

AX1240S-AP-0202C_R2X
9. Web Authentication Configuration and Operation
9.4.2 Configuration related to authentication
(6) Roaming (permitting authenticated port change communication)
configuration [Change]
The notes have been corrected as follows:
Before the change:
Notes:
Roaming is available under any of the following conditions:

Connected to a port subject to dynamic VLAN mode before and after reconnection

Authenticated VLAN before connected to a different port must be configured to the
configuration command of the port
vlan
After the change:
Note
Roaming is available under any of the following conditions:

Connected to a port subject to dynamic VLAN mode before and after reconnection
(7) Authentication exclusion configuration [Change]
(b) Authentication exclusion terminal configuration, Configuration command example has been corrected as follows
and notes have been added.
Before the change:
Configuration command example
1.
(config)# vlan 400 mac-based
(config-vlan)# mac-address 1234.5600.e001
(config-vlan)# exit
Configures the MAC address to be excluded from authentication targets to MAC VLAN ID 400 (MAC
address of the shared printer in the figure: 1234.5600.e001).
2.
(config)# mac-address-table static 1234.5600.e001 vlan 400 interface fastethernet
0/5
Configures the MAC address of a terminal to be excluded from authentication targets and where
communication is permitted on port 0/5 of MAC VLAN ID 400 (MAC address of the shared printer in
the figure: 1234.5600.e001) in the MAC address table.
After the change:
Configuration command example
1.
(config)# vlan 400 mac-based
(config-vlan)# mac-address 1234.5600.e001
(config-vlan)# exit
Configures the MAC address to be excluded from authentication targets to MAC VLAN ID 400 (MAC
18
switchport mac