Description Of The Pump (Set); General Description; Product Information As Per Regulation No. 547/2012; Pumps) Implementing "Ecodesign" Directive 2009/125/Ec - KSB S 100D Installation & Operating Manual

14 of 42

4 Description of the Pump (Set)

4 Description of the Pump (Set)

4.1 General description

Pump for handling clean or slightly contaminated water.
Verify the fluid composition against the data sheet.
Not approved for handling explosive fluids or for forming part of an explosion-proof
system!
4.2 Product Information as per Regulation No. 547/2012 (for 4" and 6"
Water Pumps) Implementing "Ecodesign" Directive 2009/125/EC
▪ Minimum efficiency index: see name plate, key to name plate (⇨ Section 4.4 Page
15)
▪ The benchmark for most efficient water pumps is MEI ≥ 0.70.
▪ Year of construction: see name plate, key to name plate (⇨ Section 4.4 Page 15)
▪ Manufacturer's name or trade mark, commercial registration number and place
of manufacture: see data sheet or order documentation
▪ Product's type and size identificator: see name plate, key to name plate (⇨
Section 4.4 Page 15)
▪ Hydraulic pump efficiency (%) with trimmed impeller: see data sheet
▪ Pump performance curves, including efficiency characteristics: see documented
characteristic curve
▪ The efficiency of a pump with a trimmed impeller is usually lower than that of a
pump with the full impeller diameter. Trimming of the impeller will adapt the
pump to a fixed duty point, leading to reduced energy consumption. The
minimum efficiency index (MEI) is based on the full impeller diameter.
▪ The operation of this water pump with variable duty points may be more
efficient and economic when controlled, for example, by the use of a variable
speed drive that matches the pump duty to the system.
▪ Information on dismantling, recycling and disposal after decommissioning: (⇨
Section 3.5 Page 12)
▪ Information on benchmark efficiency or benchmark efficiency graph for MEI =
0.7 (0.4) for the pump based on the model shown in the Figure are available at:
http://www.europump.org/efficiencycharts

4.3 Designation

Submersible borehole pump
Example: S 100D - 4 / 6
Table 4: Key to the designation
Code
S
100
D
4
6
Submersible borehole pump
Example: UPA 100C 4 - 6
Table 5: Key to the designation
Code
UPA
100
C
S 100D; UPA 100C
Description
Type series
Nominal pump size [mm]
Design status
Flow rate at best efficiency point [m³/h]
Number of stages
Description
Type series
Nominal pump size [mm]
Design status