Preparation Of Paints; Commissioning; General Rules For Making Adjustments To The Spray Gun - WAGNER GM 4700AC-H Translation Of The Original Operating Manual

VERSION 09/2011
OPERATING MANUAL
5.2

PREPARATION OF PAINTS

The viscosity of the paints is of great importance. The best spraying results are obtained
with values between 80 and 260 milli Pascal x Sec (mPas).
Please also read the technical data sheet of the paint for optimal processing, viscosity
adjustment and intermixing of the material.
5.3

COMMISSIONING

5.3.1

GENERAL RULES FOR MAKING ADJUSTMENTS TO THE SPRAY GUN

Observe safety instructions in chapter 2.
Unintentional commissioning!
Risk of injury
Before any work on the device, in the event of work interruptions
and functional faults:
Cleaning agent in the air duct!
Functional faults caused by swollen seals
Always point the spray gun down when cleaning.
Ensure that neither paint nor cleaning agents enter the air duct.
Air
Material
ORDER NUMBER DOC
WARNING
Switch off the energy/compressed air supply.
Relieve the pressure from the spray gun and unit.
Secure the spray gun against actuation.
In the event of functional faults: remedy the fault as described
in the "Trouble shooting" chapter.
CAUTION
Locking device in secured
position
2311730
GM 4700AC
19