Frame Installation - 8 - Robern CARTESIAN Series Important Safety Instructions Manual

FRAME INSTALLATION
The drawer fronts are packed separately. Do not unpack them until the room is safe from hazards. If you are ganging and / or stacking
vanities see pages 10 & 11.
1. Mark the height for the vanity frame install on the finished wall ( Fig. 1).
2. Install two of the #10 x 2" (SS674) at the locations shown in Fig. 2. Do not install tight to the wall, leave 1/8" behind the head.
3. Place the vanity frame on the screws using the top left and right keyholes ( Fig. 3). The keyhole on the left allows for up and down
adjustment.
WARNING: THESE SCREWS ARE NOT THE FINAL SUPPORT FOR THE VANITY! SEE PAGE 9 FOR FINAL BOLT UP.
1
3
© 2018 Robern, Inc. 701 N. Wilson Ave. Bristol, PA 19007 U.S.A.
800.877.2376 www.robern.com
Installation instructions
2
2-1/2"
(64 mm)
8
12" = 4"
(102 mm)
24" = 10"
(254 mm)
30" = 13"
(330 mm)
36" = 16"
(406 mm)
C L
For Single Units
Part no. 209-1231-D-Cartesian, Profiles H1 rev. 05/16/18
Cartesian™ Vanity, and Profiles™ Vanity