Robern CARTESIAN Series Important Safety Instructions Manual page 16

ADJUSTING DRAWER FRONTS
Note: Proper installation is very important for proper drawer front alignment on Robern vanities. Making sure the vanity is level and
square in all directions is very important.
1. Loosen the drawer front mounting screws (refer to page 15) to make rough adjustments. Adjust the front both vertically and
horizontally. Once aligned, tighten the screws. When working with multiple drawers, do this step on all drawer fronts before proceeding.
2. Fine adjustments can be done with the adjustment features incorporated in the locking clips. Height adjustment of the drawer front is
done with the slider. Each side may be adjusted independently.
DRAWER REMOVAL
1. If a drawer needs to be removed, no tools are required.
2. Reaching under each side of the drawer, pull the levers on the locking devices to disengage the clips, and pull out the drawer.
! Caution: You will now be carrying the weight of the drawer!
3. Place the drawer in a safe location so no damage occurs.
© 2018 Robern, Inc. 701 N. Wilson Ave. Bristol, PA 19007 U.S.A.
800.877.2376 www.robern.com
Installation instructions
16
Part no. 209-1231-D-Cartesian, Profiles H1 rev. 05/16/18
Cartesian™ Vanity, and Profiles™ Vanity