Table of Contents
Advertisement
Parts needed:
• (2) N2 - TIE SLAT - W101103
• (4) L2 - OUTER WALL SLAT - W101100
• (12) M13 - WALL SLAT - A101101
• (6) M16 - CENTER WALL SLAT - W101102
Phase Notes
• Assemble with hardware as shown.
To prevent board splitting, you
must pre-drill each board before
attaching with a 1/8" drill bit.
Step 1: Both walls should be assembled the
same way. Attach 'L2' Outer Wall Slat, 'M13'
Wall Slat and 'M16' Center Wall Slat to 'G2'
& 'K4' boards on the ladder side of fort and
'G1' & 'K4' on picnic table side of fort. The
wall slats should be pre-drilled and located
approximately 3 3/4" up from the bottom
edge of 'K4' floor board using Screws 'BR',
as shown.
N2
Step 2: Center and attach 'N2' Tie Slate
to the inside of fort walls, under the
window opening, using Screws 'BR' ,
as shown.
Fort Assembly
Phase 12
L2
M13
G2
K4
44
Hardware needed:
• (86) BR - SCREW PFH 8x1-1/8 - H100088
M16
M13
K4
L2
M13
K4
G2
L2
G1
L2
M13
M16
Advertisement
Table of Contents
