Removing The System Board - HP Engage One Retail System 141 Maintenance And Service Manual

Removing the system board

NOTE: All system board spare part kits include replacement thermal material. System boards include an
integrated Intel processor.
The system board is secured with six screws. Additionally, the system board is secured by the display
connector from the rear of the display.
To remove the system board:
1. Prepare the computer for disassembly
2. Remove the computer head unit from the stand
the stand on page
3. Remove the display panel from the computer head unit
4. Remove the heat sink
5. Remove the power button board
6. When replacing the system board, make sure the following components are removed from the defective
system board and installed on the replacement system board:
● Memory modules
● M.2 storage device
● WLAN module
7. Position the computer head unit upside down.
8. Remove the two Phillips screws and lift off the connector.
(Preparation for disassembly on page
27).
(Removing the heat sink on page
(Removing the power button board on page
(Memory modules on page
(Removing and installing an M.2 solid-state drive (SSD) on page
(Removing the WLAN module on page
(Removing and attaching the Engage One head unit to
(Removing the display panel on page
51).
45)
49)
19).
41)
54).
48)
Removing the system board 59