System Purging; Seals; Equipment Storage; Electromagnetic Compatibility - BRONKHORST MASS-VIEW series Instruction Manual

Hide thumbs Also See for MASS-VIEW series:

Table of Contents

2.10 System purging

If explosive gases are to be used, purge the process with inert dry gas like Nitrogen, Argon etc. for at

least 30 minutes. Complete purging is also required to remove such gases from the system before

exposing the system to air.

The seals fitted are compatible with the published list of gases, at the stated conditions.

The equipment should be stored in its original packing in a cupboard, warehouse or similar. Care should

be taken to not subject the equipment to excessive temperatures or humidity.

The MASS-VIEW® series carries the CE-mark.

Therefore it has to comply with the EMC requirements as are valid for these instruments.

However compliance with the EMC requirements is not possible without the use of proper cables and

connector assemblies. Do not use unshielded wire terminals.

9.17.051

BRONKHORST®

MASS-VIEW® series

Page 13

Table of Contents

Do you have a question about the MASS-VIEW series and is the answer not in the manual?