- PROFINET interface 9.17.095 9.16.146 These documents can be downloaded from www.bronkhorst.com/en/qrcoriolis or can be sent by email on request. Temperature considerations After having used the mini CORI-FLOW™ ML120 for the first time at low temperature, re-tighten the fluid adapter screws in order to prevent any leakage.
Page 3
For applications where remaining water particles might cause undesired reactions, such as corrosion, Bronkhorst strongly recommends performing an additional, adequate drying procedure. a. Mount/install instrument properly Install the mini CORI-FLOW™...
Page 4
e. Mounting position when using mini CORI-FLOW™ ML120 with external valve with purge connector For the mini CORI-FLOW™ ML120 series instruments with external liquid valve with a purge connector, the mounting position can be critical for a good quality of de-gassing. Please consult the Instruction Manual for additional information on mounting the mini CORI-FLOW instruments.
Digital RS232 or fieldbus operation Connecting the instrument with an RS232 cable to a PC will enable you to use the (free) Bronkhorst® software for Windows, such as FlowDDE and FlowPlot. See the mini CORI-FLOW™ ML120 manual (document number 9.17.097) for further explanation on...
Page 6
For a controller: send a setpoint to the mini CORI-FLOW™ ML120 and check the measured value. Make sure the mini CORI-FLOW™ ML120 indicates 0% at zero flow. Your mini CORI-FLOW™ ML120 is now ready for operation. Bronkhorst High-Tech B.V., Nijverheidsstraat 1a, NL-7261AK Ruurlo, The Netherlands T +31(0)573 45 88 00 I www.bronkhorst.com E info@bronkhorst.com...