MULTIQUIP WRS5200 Operation Manual page 50

5. Place the drive tube speed control lever in the straight
up position.
6. Place the strike tube speed and directional control lever
in the neutral (center) position.
STARTING (GAS MODE)
1. Insert ignition key into ignition switch (Figure 42) and
turn key to the ON position.
KEY
Figure 42. Ignition Switch (ON)
2. Verify that the oil pressure and charge lamps
(Figure 43) are ON.
ON
Figure 43. Oil Pressure/Charge Lamps
3. Press the GAS/LP Gas rocker switch downward
(Figure 44) on the control box to select the GAS mode,
RED light is OFF.
GAS/LPG
BUTTON
Figure 44. Fuel Selector Button (Gas Mode)
PAGE 50 — WRS5200DFPU HYDRAULIC ROLLER SCREED • OPERATION MANUAL — REV. #2 (03/08/18)
OFF
ON
START
ON
RED LIGHT "OFF"
GAS MODE
4. Press the THROTTLE rocker switch downward and
verify that the engine speed is set to idle mode,
GREEN light is OFF (Figure 45).
Figure 45. Throttle Switch (Idle)
5. If starting a cold engine or if the temperature is cold,
press the CHOKE button (Figure 46) and hold down
while cranking the engine.
CHOKE
BUTTON
Figure 46. Choke Button
6. Continue turning ignition key to the START position.
7. Listen for engine to start and release key.
8. Let engine idle for 2 to 3 minutes. Listen for any
abnormal sounds.
9. Verify that the oil pressure and charge lamps
(Figure 43) are OFF.
OPERATION
GREEN LIGHT
"OFF" (IDLE)
PRESS