Table of Contents
Advertisement
Reassembling the computer
3
4
5
6
Reassembling the computer
Before reassembling the computer, make a final check that you have installed the
upgrade in accordance with the instructions supplied with the upgrade.
Reassemble the computer using steps 4 to 6 above, but in the reverse order. Connect
the computer together again following the procedure given in Setting up the computer
on page 3.
Carry out any test procedures recommended in the instructions for the upgrade.
Switch off the computer and disconnect it from the mains supply by
unplugging the power supply cable from the wall socket.
Place the main unit on your work surface covered with the blanket, and
turn it over so that it rests on its top cover.
Remove the two fixing screws on the underside of the main unit:
Rest the main unit on its base again and slide the cover backwards to the
rear of the unit. Remove the cover completely:
Advertisement
Table of Contents
