Table of Contents
Advertisement
Initial Mode
Initial mode is used to update the OS image and upgrade the firmware. If dip switch is set as
Init mode and reset the power, the I-8000 cannot boot up with autoexec.bat and will enter
OS operation mode, in this case there is no program running on the I-8000 and the 5-digital
7-SEG LEDs will count the number as shown below:
I-8000 Series (C Language Based) User Manual, Version 1.0.1
Page: 37
Copyright © 2012 ICP DAS Co., Ltd. All Rights Reserved. E-mail: service@icpdas.com
Advertisement
Table of Contents
