Table of Contents
Advertisement
Tips & Warnings
Grounding
A good common ground reference (earth ground) is essential for proper operation of the
I-8000. One side of all control circuits, power circuits and the ground lead must be properly
connected to earth ground by either installing a ground rod in close proximity to the
enclosure or by connecting to the incoming power system ground. There must be a
single-point ground (i.e. copper bus bar) for all devices in the enclosure that require an earth
ground.
2. To mount the I-8000 on a surface
1.
Install the four mounting screws into the 4 keyhole mounting holes
2.
Fasten the screws securely
I-8000 Series (C Language Based) User Manual, Version 1.0.1
Copyright © 2012 ICP DAS Co., Ltd. All Rights Reserved. E-mail: service@icpdas.com
Page: 28
Advertisement
Table of Contents
