Installation Location And Clearance - Siemens SIMATIC HMI IRD400 Operating Instructions Manual

Installing and connecting the display unit
3.1 Preparing for mounting
3.1.3

Installation location and clearance

Selecting installation location
The display unit is designed for installation in a control cabinets. The display unit is installed
in landscape format.
NOTICE
Installation location
Non-compliance with permissible ambient conditions at the installation location may lead to
malfunctions.
Observe the permissible ambient conditions when selecting the installation location.
When selecting the mounting location for the display unit, ensure that sufficient heat
convection is possible. Avoid installation of heat generating equipment directly underneath
the display unit.
Clearance
The following clearance is required for ventilation of the display unit:
10 mm clearance at the rear side of the device.
Note
Additional clearance for connectors and cables
Take into consideration additional clearance due to the type of connector used and the
permissible bending radii of the connecting cables.
16
Operating Instructions, 05/2018, A5E36790512-AC
IRD400