Table of Contents
Advertisement
1.2.1 Instructions
for
Handling
Assemblies
Susceptible
to
Electrostatic Shock
Most of the assemblies within the SCD 1297 LCD-monitor contain components which can be
destroyed by electrostatic voltages. It is also possible for the assemblies to be damaged in such a
way that total failure does not occur.
If you (as an authorised service technician) are handling such assemblies then the following
precautions should be observed:
When such assemblies are being handled, a means of electrostatic discharge must be available. This
can be, for example, an earthed object, which can be touched to discharge electrostatic voltages.
This applies to all tools used (insulated). They must also be discharged at an earthed object.
When assemblies are removed or added to the system, the unit must always be switched off and the
power supply cable disconnected.
Vulnerable assemblies should always be held by their edge. Avoid touching tracks and contact pins.
2 General Installation
Preparation for installing the LCD-monitor include the following points:
Removal of all packaging
Checking of components for damage
Comparison of components received with those on the delivery note
Connection to the computer system and power supply
Building into your system, bearing in mind technical and ergonomic aspects
2.1 Removing the Packaging and Checking Individual Parts
After unpacking all the delivered components, they should be checked for completeness and for
possible transport damage (visual inspection). If any deficiencies are found then please contact the
service department given on the delivery note. Have the delivery note number, serial number and a
description of the deficiency to hand.
The original packaging should be kept for future transportation.
LCD-Monitor SCD1297
DOC-No.: B3 0071D1.DOC
Page 7 / 19
Advertisement
Table of Contents
