Setting The Input Signal (Inpt) - Siemens SITRANS RD200 Operating Instructions Manual

From Run mode, press Menu
scroll through choices. Use Enter/Ack
to exit at any time.
Notes:
• The relay menu is always available even if the relay option is not installed.
• Visual alarm indication is available through front panel LEDs and the
SITRANS RD Software.
• The Analog Output menu is available if selected in the Advanced Features
menu. 4 to 20 mA output option board is installed and setup at the factory.

Setting the input signal (inPt)

Enter the Input menu to set up the meter to display current (
tC
thermocouple (
The voltage input is capable of accepting any signal from -10 to +10 V DC. Select voltage
input to accept 0-5, 1-5, 0-10, or ±10 V DC signals.
The current input is capable of accepting any signal from -20 to 20 mA. Select current
input to accept 0 to 20 or 4 to 20 mA signals.
Setup meter to display current (
1. Press Menu
2. Press Enter/Ack
3. Press Enter/Ack
4. Press Up arrow
4-20
5. When is displayed, press Enter/Ack
6. Press Menu
Setup meter to display voltage (
1. Press Menu
2. Press Enter/Ack
3. Press Enter/Ack
4. Press Up arrow
0-10
5. When is displayed, press Enter/Ack
6. Press Menu
7ML19985JS01
to access any menu or press Up arrow
rtd
), or RTD ( ) inputs.
4-20
) input:
to enter Programming Mode.
to access Setup menu.
to access Input menu.
to scroll through choices;
to return to Run Mode.
0-10
) input:
to enter Program Mode.
to access Setup menu.
to access Input menu.
to scroll through choices;
to return to Run Mode.
SITRANS RD200 – OPERATING INSTRUCTIONS
to accept any entry and press Menu
4-20
), voltage (
SEtu
is displayed.
inPt
is displayed.
4-20, 0-10, tC, rtd
to accept this choice.
4-20, 0-10, tC, rtd
to accept this choice.
to
0-10
),
.
.
Page 21