Probe Mode; Storage; Recall And Delete Readings - PCE Health and Fitness 5000H User Manual

5.7

Probe Mode

There are three probe modes: AUTO, MAG and EDDY. In AUTO mode, the probe can
automatically determine the type of substrate measured. In MAG mode, the probe can only
measure on magnetic substrates. In EDDY mode, the probe can only measure on non-ferrous
metal substrates. When a magnetic substrate detected, an "F" will be shown on the right of
readings, and when a non-ferrous metal detected, a "N" will be shown. User can switch probe
mode as below.
a. Press "Left Key" once to enter menu mode ("Root" directory).
b. Press "Up Key" or "Down Key" to activate "Options" item, and press "Left Key" once to enter.
c. Press "Up Key" or "Down Key" to activate "Probe Mode" item, and press "Left Key" once to
enter.
d. Press "Up Key" or "Down Key" to activate your intended item, and press "Left Key" once to
select the item and go back. Press "ZERO Key" to back measure mode.
5.8

Storage

In general group mode (GENn), readings and statistics will be stored and not be lost when
power off. In direct group mode (DIR), readings and statistics will be lost when power off.
Each group has individual high/low limit alarm, zero calibration and multi-point calibration, user
can change these settings, and they will be stored.
In addition, user can set the system settings (e.g.: Measure Mode,Group Mode,Probe Mode
etc.), these settings will also be stored.
Note: When battery low, user must replace the battery timely. Before replacing the battery, you
need to power off the gauge firstly.
5.9

Recall and Delete Readings

•
Delete the last readings (Tips: If in measure mode, press the "UP Key" once by one
beep).
a. Press "Left Key" once to enter menu mode ("Root" directory).
b. Press "Up Key" or "Down Key" to activate "Delete Data" item, and press "Left Key"
once to enter.
c. Press "Up Key" or "Down Key" to activate "Current Data" item, and press "Left Key"
once. A dialog box will be displayed.
d. Press "Left Key" once to confirm the selection and go back, or "Right Key" to cancel
and back. Press "ZERO Key" to go back to measure mode.
© PCE Instruments
8