Pcb Transport Error - Panasonic SP22P Maintenance Manual

Check and Solutions
4-2-12

PCB Transport Error

1. Moving the camera to the recognition mark position by inching and recog-
nize again. (Fig. 1)
Check the error screen, and when the recognition mark is not at the center of recognition screen,
move the recognition mark to the center by
operation is re-started.
2. Re-recognizing the recognition camera or board after cleaning
Check the error screen, and clean the mark if it is dirty, then press
operation is re-started.
3. Re-recognizing after entering proper coordinates
∗ When the recognition error is found again, No recog and PCB board are displayed additionally.
Select either of them (Fig. 3). To quit automatic operation and teaching, press
(Fig. 1)
Re-recog The board recognition is carried out again.
No recog The next movement is carried out without
recognition.
Pass The recognition error board is passed
during the automatic operation.
Page 4-14
2
1
(Fig. 3)
UNLOCK
and , and press
(Fig. 2)
Img move rsps The moving distance of one pressing
is set.
Low : 0.01 mm, Middle : 0.1 mm,
High : 2.00 mm
(red arrow mark) The recognition screen moves to
UNLOCK
and Re-recog . The
UNLOCK
and Re-recog . The
the (red arrow mark) direction.
193C-E-MMA04-A02-02
.