How To Change Cable Connection After Initial Installation - BenQ EX Series User Manual

How to change cable connection after initial installation

To protect the curved screen, do not lay the screen face down on the desk without the
protection of the supplied cushion. If you prefer to change the cable connection after the initial
installation has been completed in
the procedures below.
1. Turn off the monitor.
Turn off the monitor and the power before unplugging
the power cable. Turn off the computer before
unplugging the monitor signal cable.
2. Tilt the monitor to its extended position.
Gently tilt the monitor to the maximum extended
position. To properly tilt the monitor, see
monitor. on page
3. Remove the back cover.
Remove the back cover from its bottom as illustrated.
Follow the instructions in
connection. on page 11
Re-install the back cover as instructed in
cover. on page 12.
How to assemble your monitor hardware on page
13.
Establish a video cable
and change connected cables.
Tilt the
Install the back
How to change cable connection after initial installation
10, follow
15