Table of Contents
Advertisement
How to change cable connection after initial installation
To protect the curved screen, do not lay the screen face down on the desk without the
protection of the supplied cushion. If you prefer to change the cable connection after the initial
installation has been completed in
the procedures below.
1. Turn off the monitor.
Turn off the monitor and the power before unplugging
the power cable. Turn off the computer before
unplugging the monitor signal cable.
2. Tilt the monitor to its extended position.
Gently tilt the monitor to the maximum extended
position. To properly tilt the monitor, see
monitor. on page
3. Remove the back cover.
Remove the back cover from its bottom as illustrated.
Follow the instructions in
on page 9
and change connected cables. Re-install the
back cover as instructed in
page
10.
12
How to change cable connection after initial installation
How to assemble your monitor hardware on page
11.
Connect the PC video cable.
Install the back cover. on
Tilt the
9, follow
Advertisement
Table of Contents
