Brother GTX Series Reference Manual page 4

DAILY AGITATION OF WHITE INK
> Perform the procedure shown below if the message "Remove the white ink cartridge
and shake it" is displayed before starting operation.
For 1 Minute
Take out the white ink cartridge from
the printer
Shake the cartridge horizontaly 100
times side by side to stir the white ink
> Repeat the same process on the other white ink cartridge! On the operation panel,
press and the White Ink refilling will be performed automatically by the printer!
MENU
OK
POUCH REPLACEMENT - VERY IMPORTANT !
Open the cartridge's lid on a flat surface and remove the empty pouch.
Unpack carefully a new ink pouch from its shipping carton.
1'
Push the green tip end of the ink pouch into the cartridge until it clicks into place.
Straighten the ink pouch to align it with the gutter of lid of cartridge, and mount in posi-
tion inside the metal spring by pulling it with your hand.
If the edge of the ink pouch is bent or undulating significantly, make it straight and flat
with your hand to avoid wrinkles.
Place the pouch in a straight alignment with the cartridge. Align lines with each other!
Close the lid, verify if the spring is rolling to the front. Place the cartridge at around 45°
and push on the 2 upper metalic latches to add a bit more tension on the ink pouch.
Attach a shelf life sticker
CLICK
4
1'
1'
For 1 Minute
included with ink pouch onto the front of the cartridge.
ALIGN
When the remaining ink level becomes
approximately 15 cm, shake the cartridge
with its cover open and with the ink pouch
slightly winded, to make the ink easier to stir
NO WRINKLES PUSH to ROLL