Table Of Contents - TECHCON SYSTEMS TS550R User Manual

CONTENTS
1. Safety ........................................................................... 3
2. Symbol Definitions ........................................................ 4
3. Specifications .................................................................. 5
4. Features ....................................................................... 5
5. To Controll Pneumatic Valve................................................... 6
5.1 Connecting the unit..................................................... 6
5.1.1 Login ............................................................ 7
5.1.2 Pressure Calibration........................................... . 7
5.2 Dispensing ............................................................. 9
5.2.1 Pressure Adjustment ......................................... 9
5.2.2 To Change Pressure Unit Display .......................... 9
5.2.3 Manual/Purge Dispense Cycle ................................ 10
5.2.4 Automatic Dispense Cycle
5.2.5 Teach Mode Setting ............................................ 11
5.2.6 To run in Continuous Mode ................................... 11
5.3 Low Pressure Alarm Setting
5.4 Stored Program in Memory Cell ................................... 14
5.4.1 To store dispense parameters ................................. 14
5.4.2 To run in Single Sequence mode ............................. 14
5.4.3 To run in Continous Sequence mode ........................ 16
5.5 Cycle Counter ......................................................... 16
5.6 To Change Password ................................................. 17
5.7 To Connect to Wi-Fi network ....................................... 19
6. Internet of Thing (IoT) ....................................................... 21
7. Software Upgrade ............................................................ 27
8. Troubleshooting .............................................................. 29
9. Maintenance ................................................................... 30
10. Warranty ........................................................................ 30
11. I/O Configuration and End of Cycle Switch
Page Number
................................. 10
...................................... 13
............................ 31
2
11. I/O CONFIGURATION AND END OF CYCLE FEEDBACK
During a dispense cycle, an open collector circuit closes and remains closed while
the valve is dispensing. Pin 3 and 4 can be as feedback signal to synchronize with
other devices. Power from an external source is allowed to pass through the circuit
to operate a 5 to 24 VDC load. Power consumption must not exceed 250 mA. The
load could be a relay, solenoid, counter, LED, or any device that will operate within
a 5 to 24 VDC range and a maximum of 250 mA.
Note: During the dispense cycle, pin 3 will be grounded. Please make sure the
external device (your machine that controls the dispenser/controller) has the same
ground as the controller.
Pin 1 (+)
Pin 2 (-)
End of Cycle Feedback
During dispensing cycle, Pin 3 is grounded (-)
End of dispensing cycle,
Pin 3
Pin 3 is not connected (opened)
Pin 4
When low pressure alarm is triggered, Pin 4 is grounded (-)
When low pressure alarm is turned off,
Pin 4 is not connected (opened)
Pin 5
To initiate a dispense cycle with
contact closure
Pin 6
Pin 5
Pin 7, 8, and 9 = Available
To initiate a dispense cycle with voltage
Chasis Ground
7508-0250_A
31