Table of Contents
Advertisement
Compliance with FCC Regulations
IDairucdOD8 to User
This equipment generates and uses radio frequency energy. If it
is
not
installed and used properly; i.e., in strict accordance with the oper-
ating instructions and reference manuals, it may cause interference to
radio or
tel~vision
reception.
It
has been tested and found to comply
with the limits for a Class B computing device pursuant to Subpart
J
of Part 15 of FCC Rules, which are designed to provide reasonable
protection against such interference when operated in a residential
installation. Operation with non-certified equipment is likely to result
in interference to radio and TV reception.
If this equipment does cause interference to radio or television recep-
tion, which can be determined by turning the equipment off and on,
the user is encouraged to
try
to correct the in terference by one or
more of the following measures.
• Reorient the receiving antenna.
• Move .the equipment away from the receiver.
• Plug the equipment into'a different outlet so that equipment and
receiver are on different branch circuits.
• Ensure that card mounting screws, attachmertt connector screws.
and ground wires are tightly secured.
• Ensun:: that card slot covers are in place when no card is installed.
The manufacturer is not responsible for any radio or 1V interference
caused by unauthorized modifications to this equipment.
It
is the
responsibility of the user to correct such interference.
If necessary, consult your dealer or an experienced technician for·
additional suggestions, or refer to the following booklet prepared
by
the Federal Communications Commission:
• How to Identify and Resolve Radio-TV Interfel·cnce Problems.
The booklet is available from the U.S. Government I>rinting Office.
Washington, D.C.
20402,
Stock
~o.
004-000-00345-4.
Advertisement
Table of Contents
