Table of Contents
Advertisement
Setting Up
Connecting the Interface Cable
The interface cable
in
your adapter ldt can be
connected to either the modem or printer port on the
back of your Macintosh. If it is connected to the printer
port,
printer outpUt will
be·
redirected to the modem port.
'Secertain that your
appli'Canoit"'\Vf.ll
redirectprlnter··'· , .
output before
you
connect
to
the printer port.
If
it
will
not,
you
could lose. data or your Mac Disk data could
become corrupted..
.
If you are not certain about your application,
connect
Mac
Disk
to the modem
port. If
you have to use
a modem that will only connect to the modem port, you
can
connect Mac Disk
to the
printer
port long enough to
use the modem, then switch back to the modem port.
Power off before you disconnect your Mac Disk. After you
switch ports, power on and start up your system again.
WARNING:
2-2
Use the shielded interface cable you r-eceived
with
your Mac Disk. Use of an unshielded cable
violates the FCC:-Class B r-equirements and voids
your warranty.
<0 Copyright 1985 Oavong Systems.
[nco
Advertisement
Table of Contents
