Advertisement
Quick Links
Download this manual
See also:
Installation Manual
XCU Fusion
316L stainless-steel dual imager camera
Quick Start Guide
Unpack
•
1x Camera unit
1x Quick Start Guide
•
Note 1: Subject to modification. Actual product and accessories may differ in appearance.
Assign IP address with DHCP...
© Siqura B.V. 2018
Version 0.4 (181904-04)
XCU Fusion QSG (MW10)
Find additional manuals, the datasheet,
the EU Declaration of Conformity, and the latest
firmware for this product at:
siqura.com/downloads/software
Mount
Wall mounted XCU Fusion
XCU Fusion ceiling mounted on XCUCM01
XCU Fusion ceiling mounted on XCUCM02
XCU Fusion wall/pole mounted on XCUCM02
Note 2: For detailed mounting instructions, download the installation manual.
Note 3: The silica gel packet inside the camera must be replaced if the camera has been
opened.
.. or assign IP address without DHCP
10.x.y.0
Video Management System
Connect to network
Pinning power connector
CAUTION: MAKE SURE THAT THE POWER SUPPLY VOLTAGE MATCHES THE
VOLTAGE RATING OF THE XCU FUSION. CHECK THE PRODUCT LABEL TO
DETERMINE THE VOLTAGE REQUIRED FOR PROPER OPERATION.
DO NOT CONNECT A 24 VAC MODEL TO A 115 VAC OR 230 VAC POWER SUPPLY!
Install Device Manager
Cat 5
NTP
Note 4: On the Siqura website, choose SDM2 2.4.0 installer or higher.
Connect and point
Connect to power (see warning below)
siqura.com
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for Siqura XCU Fusion
Summary of Contents for Siqura XCU Fusion
-
Page 1: Quick Start Guide
CAUTION: MAKE SURE THAT THE POWER SUPPLY VOLTAGE MATCHES THE Note 2: For detailed mounting instructions, download the installation manual. VOLTAGE RATING OF THE XCU FUSION. CHECK THE PRODUCT LABEL TO Note 3: The silica gel packet inside the camera must be replaced if the camera has been Note 1: Subject to modification. - Page 2 Create Admin account IMPORTANT: FOR BEST PERFORMANCE AND NETWORK SECURITY, MAKE SURE TO DOWNLOAD THE LATEST FIRMWARE VERSION FROM SIQURA.COM. THEN, UPGRADE THE FIRMWARE IN THE DEVICE MANAGER (SEE BELOW). IMPORTANT: MAKE SURE YOU CREATE AN ADMIN ACCOUNT WHEN YOU OPEN THE WEB INTERFACE FOR THE FIRST TIME.
Need help?
Do you have a question about the XCU Fusion and is the answer not in the manual?
Questions and answers