Notes on holding over the
device
Please note the following when holding the
terminal over an IC card reader or NFC
module equipped device.
Bring
mark close to the device slowly
・
without hitting it strongly.
Hold
mark over the center of the device in
・
parallel. If scanning fails even with it held in
front of the center of the scanner, slightly lift
up the terminal, or move it backwards/
forwards or to the left/right.
If there is any metal object between
・
and the other device, scanning may fail.
Putting the terminal into a case or cover may
affect communication. In that case, remove
the case or cover.
Using "Osaifu-Keitai
compatible service"
To use the Osaifu-Keitai compatible service,
set services from the Osaifu-Keitai
application.
From the Home screen,
1
u
[Osaifu-Keitai].
If the initial settings are not complete,
・
the initial setting screen appears.
Follow the onscreen instructions.
Select a service.
2
Set the service.
3
Set it from the service application or the
・
website.
Hold
4
an IC card reader.
❖ Information
You can use the service by holding over an IC card
・
mark
reader without activating Osaifu-Keitai compatible
application.
These services are available even when the terminal
・
is off. However, they may not be available if the
terminal has been off for a long time, the battery is
too low, or while certain period of time after the
powering on the terminal.
mark of the terminal over
126
Apps