Replacing
the Clamp
Safe Place Transmitters User Guide
0510-1121-G
In some cases, you need to replace
damaged transmitter clamps. This is done
by opening the existing clamps, snapping
them off of the transmitter, and inserting
new clamps.
To replace a transmitter clamp:
1. Open the clamps all the way and gently
remove them from the transmitter.
2. Insert the first clamp into the transmitter
by inserting the right oval-shaped pin
into the hole on the right of the
transmitter.
3. Next, line the left oval-shaped pin up
with the hole on the left side of the
transmitter.
4. Gently snap the left oval-shaped pin into
the hole.
5. Close and secure the clamp.
Testing and Care
Page 29 of 36