Standard Infant - RF Technology Safe Place Smart Sense User Manual

General Information
Standard
Infant
Page 18 of 36
To band a Standard Infant transmitter:
1. Cut off 6-8" of the banding material from
the roll.
2. Open the clamps of the transmitter by
gently pulling them outward, one clamp
at a time, from the top of the transmitter.
3. Thread with duck-side of banding
material up.
4. Advance the banding material from the
bottom slot out through the top slot on
the clamp.
5. Secure only one-side of the transmitter.
6. Place the transmitter with banding
material around infant's ankle then
thread and secure second clamp. The
band must be tight enough to help stop
the transmitter from slipping off, and
loose enough to avoid discomfort.
7. The transmitter becomes active one
minute after the clamps are snapped
into place. The 60 second grace period
allows the transmitter to be re-opened
once the transmitter's second clamp
has been secured.
Safe Place Transmitters User Guide
0510-1121-G