RF Technology Safe Place Smart Sense User Manual page 28

Testing and Care
Page 26 of 36
2. Use the provided brush to clean the
hard-to-reach areas. After each use,
brushes can be disposed of or
disinfected with alcohol according to
your facility's infection control
procedures.
3. Disinfect the transmitter with an
approved cleaner.
NOTE: In order to avoid nuisance alarms,
cleaning procedures must be performed at
least 100 feet from any Alarming Band
Zone.
CAUTION: Using an approved cleaner does
not confirm the suitability of the cleaner to
meet your infection control standard; it only
indicates that the transmitter will not be
harmed by the cleaner.
The transmitters may be wiped, sprayed or
rinsed with water or the approved cleaners
during cleaning, but must not be soaked.
Soaking transmitters may result in
equipment and/or system failure.
4. Allow the cleaner to remain on the
transmitter for the amount of time
specified by the manufacturer. When
using surface disinfectants and
decontaminant cleaners, always follow
the manufacturer's instructions.
5. Wipe the transmitter with a clean cloth
or towel, and then allow the transmitter
to air-dry. The transmitter can also be
rinsed with water, if required to in the
manufacturer's instructions.
Safe Place Transmitters User Guide
0510-1121-G