Advertisement
TC620 - 800W Bridge Saw
Assembly & Operation
Remove the saw from its carton, lay carefully on
its side.
Always use the following procedure, in the order
given, when assembling the water reservoir.
Mount the first table leg in place. Mount the first
cushion in the leg. Mount the water reservoir.
Mount the other 3 legs according to the same
instructions. Tighten all parts.
Put the water reservoir straight up.
Switching on and off
To switch the machine on, set the on/off
switch to '-'.
To switch the machine off, set the on/off switch
to 'O'.
Operating Instructions
Straight Cuts
Unfasten blade carriage retaining bolt.
Push the blade carriage to its furthest point away
from the operator. Place the tile in position on the
cutting table so that it rests against the measuring
scale and mitre guide.
Set the size of cut required on the measuring
scale and lock the mitre guide.
Switch on the machine.
Pull the blade carriage steadily towards you,
cutting through the tile. When the cut is complete,
switch off the machine, removing the cut tile
pieces and any debris.
Tel: +44 (0) 1253 789180
05
Advertisement
