Advertisement
Angular Cuts
Place the tile in position on the cutting table so
that it rests against the measuring scale and the
mitre guide.
Loosen the winged screw on the mitre guide and
set the angle of cut required.
Pull the blade carriage steadily towards you,
cutting through the tile.
When the cut is complete, switch off the machine,
removing the cut tile pieces and any debris.
06
Mitre Cuts
Loosen the two knobs at either end of the bridge
Tilt the bridge to the desired angle (up to 45
re-tighten.
Place the tile in position on the cutting table so
that it rests against the measuring scale and mitre
guide.
Switch on the machine. Pull the blade carriage
steadily towards you, cutting through the tile.
When the cut is complete, switch off the machine,
removing the cut tile pieces and any debris.
Tel: +44 (0) 1253 789180
) and
O
Advertisement
