Advertisement
Quick Links
103620
TC620 - 800W Bridge Saw
Owner's Safety and Operating Manual
Safety First
Read manual before use. Keep hands arms and face clear
of blade whilst in use. Always have safety guard in place
when machine is switched on at the mains.
Always wear Vitrex Protective Equipment when using
hand or power tools.
Advertisement
Related Manuals for QEP TC620
Summary of Contents for QEP TC620
- Page 1 103620 TC620 - 800W Bridge Saw Owner’s Safety and Operating Manual Safety First Read manual before use. Keep hands arms and face clear of blade whilst in use. Always have safety guard in place when machine is switched on at the mains.
- Page 2 TC620 - 800W Bridge Saw Owner’s Safety and Operating Manual Contents Safety Instructions ........... 3 Machine Specification & Electrical Requirements ..4 Assembly & Operating Instructions ...... 5-7 Maintenance ............7 Warranty ..............8 Tel: +44 (0) 1253 789180...
-
Page 3: Safety Instructions
TC620 - 800W Bridge Saw Safety Instructions To use this tool correctly, you must • Never lift the pump by the mains cable or hose, but only by the housing. observe the Safety Regulations, the Assembly Instructions and the Operation •... - Page 4 - Smoke or smell caused by scorched insulation IMPORTANT For best results with your new TC620 - 800W Bridge Saw allow the blade to do the work, rather than forcing the tile through the machine. Should the blade stop, simply ease the tile away and then continue cutting using slightly less pressure.
-
Page 5: Operating Instructions
TC620 - 800W Bridge Saw Assembly & Operation Operating Instructions Straight Cuts Remove the saw from its carton, lay carefully on its side. Unfasten blade carriage retaining bolt. Always use the following procedure, in the order given, when assembling the water reservoir. -
Page 6: Mitre Cuts
Angular Cuts Mitre Cuts Place the tile in position on the cutting table so Loosen the two knobs at either end of the bridge that it rests against the measuring scale and the mitre guide. Loosen the winged screw on the mitre guide and Tilt the bridge to the desired angle (up to 45 ) and set the angle of cut required. - Page 7 TC620 - 800W Bridge Saw Maintenance Emptying water from tray • The machine does not require any special maintenance. • Regularly remove grindings from the housing and the covers. • The unit must not be operated if the mains connection lead is not in perfect condition.
- Page 8 Consequently, please be advised that specifications, performance, appearance, Tel: +44 (0) 1253 789180 and dimensions of QEP/Vitrex products are subject to change without notice. For Fax: +44 (0) 1253 789182 more up-to-date information about our range of products, please contact our...