Table of Contents
Advertisement
6 6 0 0 0 0 8 8 5 5
PORTABLE WET SAW
OWNER'S MANUAL
and Parts List
INCLUDING ALL
OPERATING INSTRUCTIONS
CAUTION!
Read and follow all safety and
operating instructions before
using this saw.
080800
Q.E.P. CO., INC.
1081 Holland Drive
Boca Raton, FL 33487
(561) 994-5550
City of Industry, CA 91749
Mexico, MO 65265
Bramalea, ON Canada L6T 1A7
Advertisement
Table of Contents
Related Manuals for QEP 60085
Summary of Contents for QEP 60085
- Page 1 6 6 0 0 0 0 8 8 5 5 PORTABLE WET SAW OWNER’S MANUAL and Parts List INCLUDING ALL OPERATING INSTRUCTIONS Q.E.P. CO., INC. CAUTION! 1081 Holland Drive Read and follow all safety and Boca Raton, FL 33487 operating instructions before (561) 994-5550 using this saw.
- Page 2 6 6 0 0 0 0 8 8 5 5 PORTABLE WET SAW OWNER’S MANUAL and Parts List INCLUDING ALL OPERATING INSTRUCTIONS TABLE OF CONTENTS Safety Guidelines ..2,3 Features of the Wet Saw....4 Electrical / Motor Specifications ..4 Unpacking, Assembly & Set-Up ..4 Saw Operation ..5 Saw Maintenance ..5 Diagram of Wet Saw6...
- Page 3 SAFETY GUIDELINES READ THIS OWNER’S MANUAL COMPLETELY AND MAKE SURE YOU UNDERSTAND ALL OF ITS SAFETY GUIDELINES. Ensure the power switch on your tile saw is in the “OFF” position before plugging it in. 2. Reduce the risk of unintentional starting. Make sure switch is in off position before plugging in. 3.
- Page 4 EXTENSION CORDS A. Use only extension cords that are intended for outdoor use. These extension cords are identified by a label, “Acceptable for use with outdoor appliances; store indoors while not in use”. Use only extension cords having an electrical rating not less than the rating of the product. Do not use damaged extension cords. Examine extension cord before using and replace if damaged.
- Page 5 ELECTRICAL / MOTOR SPECIFICATIONS FEATURES OF THE WET SAW 115V & 230V MOTOR SPECIFICATIONS Direct-drive, ⁄ HP motor, 3400 RPM. • Horsepower ⁄ H.P. ⁄ H.P. 2. Flat cutting table to cut tile of any size. 7" blade cuts • Volts 115V 230V tile up to 33 mm thick.
- Page 6 SAW OPERATION DIAGRAM 3 • TAKE OUT THE ELECTRICAL CORD to connect to the power source. The electrical cord is stored underneath the cutter. (See Diagram 3) • RAISE THE BLADE GUARD up to the highest position, then open the left cutting table to fill the reservoir with water to the recommended level.
-
Page 7: Parts List
DIAGRAM OF WET PARTS LIST #60085 PORTABLE WET SAW DESCRIPTION Wing Screw Blade Guard Wing Nut Guard Support Guard Support Screw 7” Continuous Rim Blade Inner Washer Rubber Ring Magnet Adjustable Right Cutting Table Tile Guide Frame Carrying Handle – Folding...
Need help?
Do you have a question about the 60085 and is the answer not in the manual?
Questions and answers