Advertisement
Machine Specification & Electrical Requirements
Power Supply
Motor
RPM (No load)
Maximum Sound Level*
Blade size
Maximum Depth of Cut (with new blade)
Maximum Depth of Cut at 45
Mitre Cutting Angle
Cutting Angles
Machine & Accessories packed weight
*Note: If the sound intensity level exceeds 85 db (A) ear protection should be worn by the operator.
• Ensure that the mains voltage corresponds
to the instruction plate - a single phase
socket with two contacts and an earth is
obligatory.
• Use an approved RCD circuit breaker
between the machine and the electrical
power point.
• To reduce the risk of unintentional starting,
make sure that the switch is in the OFF
position before plugging in.
• Repair or replace damaged or worn cable
immediately after first disconnecting from
mains supply.
• Electrical faults must only be carried out by
a qualified electrician.
• Immediately switch off the saw in the
case of:
- Excessive sparking of the brushes
- Malfunction of the main plug, socket
or damaged cables
- Broken switch
- Smoke or smell caused by scorched
insulation
IMPORTANT
For best results with your new TC620 - 800W
Bridge Saw allow the blade to do the work, rather
than forcing the tile through the machine. Should
the blade stop, simply ease the tile away and
then continue cutting using slightly less pressure.
04
(with new blade)
O
• WARNING-To reduce the risk of electrocution,
keep all connections dry. Do not touch the plug with
wet hands. Ensure that water cannot run back along
the cable from the machine and into the plug socket.
The contents of the box should include the following:
• TC620 - 800W Bridge Saw
• 200mm Diamond Blade
• Wrenches
• Water Pump and Tray
• Owner's Safety & Operating Manual
230v/50Hz
800W
2950 RPM
84.2 dB (A)
200mm x 22.2mm bore
35mm
30mm
0
-45
degrees
O
O
0
-45
degrees
O
O
34.5 kg
Tel: +44 (0) 1253 789180
Advertisement
