Page 1
STK# 60024 24" PROFESSIONAL TILE SAW OWNER’S MANUAL SCIE Á CARREAUX PROFESSIONNELLE DE 61cm MANUEL D’UTILISATION SIERRA DE LOSETAS PROFESIONAL DE 61cm MANUAL DE OPERACIÓN CAUTION! Read and follow all safety and operating instructions before using this saw. ATTENTION! Lire et suivre toutes les directives de sécurité...
STK# 60024 24" Professional Tile Saw Scie á Carreaux Professionnelle de 61 cm Sierra de Losetas Profesional de 61 cm TABLE OF CONTENTS TABLE DES MATIÈRES ABLA DE CONTENIDO Safety Instructions for Tile Saw ..3 Instructions de Sécurité pour Instrucciones de Seguridad de Electrical Requirements ....4...
SAFETY INSTRUCTIONS FOR TILE SAW READ THIS OWNER’S MANUAL COMPLETELY AND MAKE SURE YOU UNDERSTAND ALL OF IT’S SAFETY GUIDELINES. 1. KEEP GUARDS IN PLACE and in working order. 2. REMOVE ADJUSTING KEYS AND WRENCHES. Before turning on the tile saw, make sure the keys and adjusting wrenches have been removed.
29. POSITIONING OF TILE SAW (See Illustration 1) A. To avoid the possibility of the appliance plug or receptacle getting wet position the tile saw to one side of a wall-mounted receptacle to prevent water from dripping onto the receptacle or plug. The user should arrange a “drip loop”...
MOTOR ASSEMBLY INSTALLATION CAUTION: FOLLOW ALL OFTHE ASSEMBLY & INSTALLATION INSTRUCTIONS COMPLETELY BEFORE CONNECTINGTHE SAW TO A POWER SOURCE OR TURNING THE MOTOR ON. MOTOR ASSEMBLY 1. Remove motor assembly (5) and saw-frame assembly (6) from the box. (See Diagram) 2.
WATER PUMP INSTALLATION WATER PUMP 1. Remove the water pump from its box and ensure that it is not cracked or INSTALLATION damaged in any way (See Diagram) 2. Attach the end of the plastic tubing, hanging down from the blade guard, to the water pump nipple.
CUTTING DEPTH CUTTING DEPTH 1. The recommended cutting depth for all materials is ⁄ " below the top surface of the cutting table. (See Diagram) 2. To adjust cutting depth, loosen the large motor mounting plate adjustment knob, and move up or down. BELT REPLACEMENT CAUTION: ALWAYS TURN OFF SAW AND UNPLUG FROM POWER SOURCE BELT REPLACEMENT...
SAW OPERATION 1. Make sure you have read this manual completely before operating your saw. 2. Make sure that there is sufficient water in the water pan to cover the inlet on the water pump, and that water is being supplied to the saw blade before attempting to cut any material. 3.
EXPLODED PARTS TABLE EXTENSION FRONT Easily slips onto the leading edge of the cutting table for maximum support when cutting larger tile. MITER BLOCK TABLE EXTENSION SIDE Easily slips onto the leading edge of the cutting table for maximum support when cutting larger tile.