Advertisement
TC620 - 800W Bridge Saw
Safety Instructions
To use this tool correctly, you must
observe the Safety Regulations, the
Assembly Instructions and the Operation
Instructions contained in this Manual.
All persons who use and service the
machine must be acquainted with this
Manual and must be informed about any
potential hazards.
Children and infirm people must not use
this tool. Children must be supervised at
all times if they are in the area in which
the tool is being used.
It is also imperative that you observe the
accident prevention regulations in force in
your area. The same applies for general
rules of occupational health and safety.
• Make sure that the cutting disc is correctly
screened by the guard.
• Never remove the riving knife. The distance
3
between the cutting disc and the riving knife
should not exceed 5 mm.
4
• Do not use cutting discs which are bent,
deformed or otherwise damaged.
7
• Do not use cutting discs which do not comply
with the specifications stated in this manual.
7
• Never start cutting tiles before the machine
reaches full speed.
8
• Never attempt to cut extremely
small workpieces.
• Do not leave the work area until the
machine has been switched off and the cutting
disc has come to a complete standstill.
• Never attempt to stop the cutting disc by
exerting pressure on the side of the disc.
• Before use check the pump for damage.
Should the pump be damaged, it must not be
used.
• Never let the pump run dry.
• Never lift the pump by the mains cable or
hose, but only by the housing.
• Always unplug the machine before
performing any maintenance.
• Do not use the machine before it has been
completely assembled and installed
according to the instructions.
• Do not perform any design, assembly or
construction activities on the table while the
machine is switched on.
• Unplug the machine and clean the table
before leaving the work area.
Tel: +44 (0) 1253 789180
03
Advertisement
