Table of Contents
Advertisement
4.
Setup Test Mode
The Setup Test Mode can be used to control the Output Terminal only by this product to verify wiring, etc. With
the use of the Setup Test Mode, the operation of the link between the Output Terminal and the equipment can be
checked from this product.
Below is an explanation on the use of the Setup Test Mode:
1.
The "Set" switch, located on the side of this product, has Switch 1 turned OFF, Switch 2 turned ON and
Switch 3 turned OFF before the power is switched on.
2.
Refer to the table below for the Output Terminal number that coincides with the operation when selected with
4
the "Set" Switch. The Power Supply LED turns on when the selected output terminal is ON and turns off
when the selected output terminal is OFF.
3.
If the "Clear" switch is pushed, in cases where the output terminal selected with the Mode Switch is OFF, it
will change to ON, and, in case it is ON, will change to OFF.
4.
To exit the Setup Test Mode, set all "Set" Switches in the OFF position to return to the "Normal Operation
Mode" configuration and reapply the power.
24
1
2
3
ON↓
Output Terminal
Block
1
1
OFF
2
OFF
3
OFF
4
OFF
5
ON
6
ON
7
ON
8
ON
1
2
3
ON↓
Dip Switch
Set Switch
2
3
OFF
OFF
OFF
ON
ON
OFF
ON
ON
OFF
OFF
OFF
ON
ON
OFF
ON
ON
Advertisement
Table of Contents
