Specifications; General Specifications - Patlite PHC-D08 User Manual

Interface converter
Table of Contents

Advertisement

5.

Specifications

5.1. General Specifications

Model
Rated Voltage
AC Adaptor
Operating Voltage Range
Standby
Rated Current
Consumption
Maximum
Standby
Rated Power
Consumption
Maximum
Operating Ambient Temperature
Operating Ambient Humidity Range
Storage Ambient Temperature Range
Storage Ambient Humidity Range
Mounting Location
Mounting Direction
Protection Rating
Insulation Resistance
Withstand Voltage
Mass (Tolerance ±10%)
Outer Dimensions
Compliance Standards
USB Port
Interface
Serial Port
USB Port
Communication
Method
Serial Port
External Contact Output
Number of Contacts
Contact Specifications
Rated Voltage
Rated Current
Failure Rate P Level
Applicable Wires
Power Output
Applicable Wires
Control Unit
Accessories
Options
PHC-D08
PHC-D08N
24V DC (Main Unit) 5V DC (USB Bus Power)
Input: 100V - 240V AC (50/60Hz) Output: 24V DC
90V - 264V AC (With AC Adaptor used)
7mA (at 24VDC) 18mA (at 5VDC)
600mA (at 24VDC) 330mA (at 5VDC)
0.4W (at 100VAC) 0.2W (at 24VDC) 0.1W (at 5VDC)
16W (at 100VAC) 14.5W (at 24VDC) 1.8W (at 5VDC)
20% - 85%RH (No dew or condensation accumulation)
20% - 85%RH (No dew or condensation accumulation)
More than 10MΩ at 500VDC between the terminals and the chassis
1500VAC for 1min between terminals (10mA or less) and chassis without breaking insulation
Refer to Outer Dimensional Drawing
Conforms to the CE requirements: (EN 55022 (ClassA), EN 55024)
FCC Part 15 Subpart B Class A
UL/CSA 60950-1 (For PHC-D08N)
USB 2.0 Conformity (supports Bus Power) Standard B Type (Female)
RS-232C Conformity D-Sub 9 pin (Male)
CDC (Communication Device Class) Protocol
Asynchronous (Baud Rate: 9600bps, No Parity, Stop Bit=1bit, Data Length: 8bit, No Flow Control)
Non-voltage Contact (Normally Open)
5VDC/ 10mA (at a switching rate of 120 operations per minute)
Solid: Φ0.4mm - Φ1.2mm (AWG26 - AWG18)
Element Wire Diameter: Φ0.18mm or more
Screwless Terminal Block; 24VDC/500mA or less
Solid: Φ0.4mm - Φ1.2mm (AWG26 - AWG18)
Element Wire Diameter Φ0.18mm or more
AC Adaptor (PHC-D08 only), Installation Manual, Rubber Feet
AC Adapter included
AC Adapter not included
0
C - +40
C
o
o
-10
C - +60
C
o
o
Indoor Only
Upright
IP 20
370g
RoHS Directive (EN 50581)
Screwless Terminal Block
8 Contacts
30VDC
3A
Stranded: 0.2mm
- 0.75mm
2
Stranded: 0.2mm
- 1.25mm
2
"Clear" Switch, "Set" Switch
None
(AWG24 - AWG20)
2
(AWG24 - AWG16)
2
25
5

Advertisement

Table of Contents
loading

This manual is also suitable for:

Phc-d08n

Table of Contents