Table of Contents
Advertisement
5.2. Functional Specifications
Contact Output Control
Identification (ID) Number Setup
"Clear" Switch
Power Source Display
Buzzer Alarm Sound
Operating Mode Switch
Normal Operation Mode
PHU Compatibility Mode
Firmware Rewriting Mode
7
26
Contact outputs are controlled in correspondence to control commands
The ID set up is controlled in correspondence to control commands, and is recorded in memory
Switches off the Signal Tower lights and buzzer
The operating status is shown by a power LED
A slide switch selection of 3 levels (High, Low, Mute) to adjust the buzzer sound
Operating Modes are changed with a DIP switch
This mode is used for communication protocol with the PHE
This mode is used to simulate the communications protocol for the PHU
This mode is used when updating this product's firmware via USB
Advertisement
Table of Contents
