Set" Switch; Clear" Switch - Patlite PHC-D08 User Manual

2.5. "Set" Switch

The operation mode of this product can be changed by changing the set switch located on the side of this product,
before power activation.
The operation modes available are as follows:
Operation Mode
Normal Operation
Setup Test
Firmware Update
• For instructions on updating the firmware, download the instructions from Patlite's home page
MEMO
and check the manual.
• When in the "Setup Test" and "Firmware Update" Modes, the commands for the "Normal
Caution Operation Mode" will not work. Therefore, put the "Set" Switches in the "Normal Operation
Mode" and reactivate the power before sending commands.

2.6. "Clear" Switch

Pressing the "Clear" switch will turn off the output terminals.
1 2 3
ON↓
Set Switch
1 2 3
OFF OFF OFF
OFF ON OFF
ON OFF OFF
1 2 3
ON↓
Set Switch
Function
Operation by commands of
"3.2. Frame Format"
Operation by "4. Setup Test Mode"
Updating firmware of this product
2
13