2.4. "Set" Switch
The operation mode of this product can be changed by changing the "Set" switch located on the side of this
product, before power activation.
2
The operation modes available are as follows:
MEMO
• During normal operation mode and firmware update mode operation, even if it sends commands during
the PHU compatibility mode, don't operate it. After changing Modes with the Set Switch, re-switch on
the power source before transmitting.
• During PHU compatibility mode, or firmware update mode operation, even if it sends the command in
normal operation mode, don't operate it. After changing Modes with the Set Switch, re-switch on the
power source before transmitting.
2.5. Buzzer Switch
It is possible to adjust ON or OFF by moving the buzzer switch left and right.
MEMO
10
1
2
ON↓
Operation Mode
Normal Operation Mode
PHU Compatible Mode
Firmware Update Mode
• For instructions on updating the firmware, download the instructions from Patlite's home page
and check the manual.
• If it is set to OFF, the buzzer not sound
3
Set Switch
1
2
3
Operation by commands of
OFF
OFF
OFF
"3.2. Normal Operation Mode"
Operation by commands of
OFF
OFF
ON
"3.2. Normal Operation Mode"
ON
OFF
OFF
Updating firmware for this product
Caution
1
2
3
ON↓
Set Switch
Function
DIP Switch
ON
OFF