Table of Contents
Advertisement
Getting Started
Control Software
ET-MWP100G is controlled using a Multi Window Processor software application in PC.
Software
Other applications
Connecting to ET-MWP100G
The initial connection between the ET-MWP100G and the control PC should be via RS232 using
the connector on the rear of the unit (using an USB to RS232 adaptor if your PC does not have
RS232).
Once connected, power up the unit – at first the ET-MWP100G will set its fans at full speed. As the
unit progresses through the power up sequence you will see that the lights on the input/output
modules will turn green before the final unit checks after which the LED indicator on the front panel
will change from red to green.
With the unit is initialised and ready to use, start the control software and login. If required the
Ethernet port on the ET-MWP100G can now be configure to allow the unit to be controlled over
a network.
Microsoft Windows XP + Windows 7,
Windows 8 (32 or 64 Bit)
Microsoft.NET.4, Microsoft Silverlight
8
Advertisement
Table of Contents
