Table of Contents
Advertisement
Case 2 : Crop window without streching image
Crop Input function is crop the specific area and strech the image to fulfill original window size.
So that, if you need to trim the data, need to make sure to adjust window aspect ratio.
FAQ's
How do I replace a module that has failed on ET-MWP100G?
put in a replacement module. Although changing the module is possible with the system powered up, you
must reboot the unit for it to be recognised.
I am not getting any outputs on my screen or outputs are flashing or showing snow.
normally indicate an issue with HDCP where the unit is protecting the high definition content from being
copied. Enable HDCP on the Input and Output you are using.
Is there a quick health check I can carry out on my unit?
so set the unit up with your equipment as described in this training guide. This will hopefully determine
whether or not the unit is actually faulty and prevent units from being returned unnecessarily. Check the
troubleshooting tips of the manual. Don't presume it is the unit that is causing the problem. Check that the
equipment being used with it is fully working and setup correctly – bypass the unit if possible by connecting
the video source directly to the video display. Check the AC power. Is it present and is the unit turned on?
Check that all cables are properly plugged in and are not damaged and then make certain that all equipment
connected to the unit is working properly. It is also worth ensuring that the latest firmware is installed in the
unit – although, again, user settings are lost during a firmware update.
Pull the failed module from the unit and
Many 'faults' are due to incorrect set-up or use
33
This will
Advertisement
Table of Contents
