Table of Contents
Advertisement
together to represent the way they are physically mounted. Normally, we use the Image Positioning
Mode to change the position of Output displays.
Rotation – a control to change the rotation of the Output display in one degree
increments/decrements.
Resolution – Allows you to edit the Output setting as selected in the General/Outputs menu.
Display Type - Allows you to edit the Output setting as selected in the General/Outputs menu.
By selecting one of the output displays an Add
Output dialogue allows you change the Actual
Size of the display to adjust the display size for
bezels and under scans.
You can also change the Display Type which
will also change the setting in the
General/Outputs menu.
Hitting OK will place a representation of the Output
display on your Layout which will be centred over a 0/0
cross hair which indicates the centre of the Layout area.
The side bar shows settings relating to the
Output display that is currently selected.
Zoom All – changes the Zoom value to include
all Output displays in your layout.
Centre Layout Origin – Centres the layout to
0/0.
Name – allows you to change the Output
name.
Width/Height in Layout – this is where you can
edit the size you set when you originally
selected the Output to be shown on the
Layout.
Playout Centre – we can move the displays
using these controls to place the displays
Underneath the Take button you can select an
alignment grid using Grid Setup.
Grid Setup gives you fill control over the Grid
including Step Size for spacing, Rotation and
Offsets.
17
Advertisement
Table of Contents
