Assemble Wheels; Assemble Roller Bar/ Extension Bar; Locking Knobs; Mounting The Miter Saw - PowerTec MT4008 Owner's Manual

ASSEMBLE WHEELS

Refer to Figure 4
• Slide the axle through the axle bracket, turn the axle
until the machined end fits into the inside bracket
hole. Place one small (Ø8) washer and nut onto axle.
Tighten nut.
NOTE: The axle has a retaining ring on one end and is
machined to fit the axle bracket hole on the other end,
make sure the machined end is inserted into the axle
bracket first.
• Slide one larger (Ø12) washer and the wheel on the
axle. Secure in place with the small (Ø8) washer and
nut. Tighten nut. NOTE: Raised hub goes to the inside.
• Repeat with other wheel.
Figure 4
Nut
Washer
(Ø8)
Washer
(Ø12)
Axle
Washer
(Ø8)
Nut

ASSEMBLE ROLLER BAR/ EXTENSION BAR

LOCKING KNOBS

Refer to Figure 5
• Place the roller arms into the roller bar supports, slide
up and down to desired location and secure in place
with locking knobs (plain threads).
• Assemble locking knobs (threads with plastic cap) to the
bottom of the frame as shown.
ASSEMBLY
Wheel
Axle Bracket
Retaining
Ring
Figure 5
Locking Knob

MOUNTING THE MITER SAW

Refer to Figure 6-7
WARNING
Risk of accidental starting and serious personal injury.
Unplug the miter saw before attaching it to the miter saw
stand.
WARNING
Risk of serious personal injury. Always make sure the
miter saw is fully supported and securely attached to
a level work surface. Make sure the miter saw stand is
located on a flat surface.
WARNING
Do not mount a table saw on this miter saw stand.
Aggressive feeding of sheet materials into a table saw
could cause the stand to tip over.
NOTE: This miter saws stand is to be used with miter
saws with four mounting holes in a rectangular pattern
• Mount the miter saw to the quick-release mounting
brackets using the supplied hardware (mounting bolt,
washer, lock washers and nut) as shown.
Figure 6
Bolt
3
Roller Bar
Locking
Knob
Nut
Lock Washer
Flat Washer
3