Operations; Roller Bars/Extension Bars Adjustment; Material Supports - PowerTec MT4008 Owner's Manual

• The quick release mounting brackets hook onto the
miter saw stand frame. Using the handles on the
quick release mounting brackets, lift the miter saw and
position the quick release mounting brackets onto the
miter saw stand as shown in Figure 7 (SAW IS NOT
SHOWN TO ALLOW VISIBILITY OF THE RAILS AND
BRACKETS).
Figure 7
4
• Lower the saw into place and press the locking levers
down to lock the mounting brackets into place.
4
WARNING
Do not use the miter saw stand for scaffolding or as a
ladder. Make sure to securely tighten all fasteners before
using. Maximum capacity is 330 lbs (150 kg). Power tools
on the miter saw stand should not exceed a combined
overall height of 60" (152.4 cm) from the floor.
NOTE: For your convenience this stand is equipped with
tool trays and a mesh bottom to help prevent accidental
4
dropping of tools.
ROLLERS BARS/EXTENSION BAR
ADJUSTMENT
Refer to Figure 8
The extension bars move in and out to properly support
the workpiece.
The roller bars are used as directional rollers or with the
extension bars as stationary stop guides.
• Loosen the locking knobs, slide the extension bar in or
out to the required position, tighten the locking knobs.
• Loosen the locking knobs, slide the roller bars up and
down to desired location, tighten the locking knobs.

MATERIAL SUPPORTS

Refer to Figure 8
Fold the material supports out to stack extra material for
easy excess.
OPERATION
Figure 8
Roller Bar
Extension
Bar
Locking
Knob
Material
Support
Tool Trays
Locking
Knob
Release Locking
Levers Knob
Material
Support
Tool Trays
Roller Bar
Locking
Knob