Unfold The Work Legs; Assemble Handle; Assemble Roller Bar/ Extension Bar; Locking Knobs - PowerTec MT4000 Owner's Manual

ASSEMBLE HANDLE

Refer to Figure 4
• Secure handle to frame with hardware supplied.
Figure 4
Nut
Lock Washer
Axle

UNFOLD THE WORK LEGS

Refer to Figure 5
• Place the miter saw stand on a flat surface with the
folded legs facing up.
• Depress the release lever and rotate the leg until it
clicks and locks into the open position. Repeat for each
leg.
• The stand should be stable and should not rock. One
leg is adjustable, if adjustment is needed, turn the
adjustment nut in or out to the required position.
Figure 5
• Place the miter saw stand in the upright position on a
flat surface.

ASSEMBLE ROLLER BAR/ EXTENSION BAR

LOCKING KNOBS

Refer to Figure 6
• Place the roller arms into the roller bar supports, slide
up and down to desired location and secure in place
with large locking knobs.
ASSEMBLY
Flat Washer
Handle
Bolt
• Assemble the small locking knobs to the frame
as shown.
Figure 6
Small Locking Knob
Pig Tail Cord
Connection Plug
Pig Tail Cord

PIGTAIL CORD

Refer to Figure 6
WARNING
Plugs must match the outlet. Never modify the plug in any
way.
The miter saw stand is equipped with three outlets. The
mounted miter saw can be plugged in along with two other
power tools.
To use the outlets:
• Plug the pigtail cord into the connection plug located
under the frame.
• Plug the other end of the pigtail cord into an appropriate
outlet.

MOUNTING THE MITER SAW

Refer to Figure 7-8
WARNING
Risk of accidental starting and serious personal injury.
Unplug the miter saw before attaching it to the miter
saw stand.
WARNING
Risk of serious personal injury. Always make sure the
miter saw is fully supported and securely attached to
a level work surface. Make sure the miter saw stand is
located on a flat surface.
3
Roller Bar
3
Large
Locking
Knob