Panasonic KX-HTS32 Programming Item List page 39

Screen / Tab
1.Port-Analog - Pulse Speed
Dialing
DTMF Width
Disconnect Time
1.Port-Analog - Caller ID(FSK) -
Caller ID Carrier Detection
Caller ID(FSK) - END
Detection
Caller ID(FSK) -
Header Examination
Caller ID(FSK) -
Detection Start Timer
Caller ID(FSK) -
Detection Timer
Caller ID(DTMF) -
Start Code 1
Caller ID(DTMF) -
Start Code 2
Caller ID(DTMF) -
Information Start Code
Caller ID(DTMF) - End
Code
Caller ID Header[03]
Setting item
Selects the speed at which
pulse dials are sent to the
analog trunk.
Selects the length of the DTMF
tone sent to the analog trunk.
Specifies the length of time
after a trunk is disconnected,
during which the PBX cannot
seize the line.
Enables the PBX to detect the
carrier when receiving Caller
ID.
Selects the method used to
detect the end of Caller ID
information.
Enables the PBX to check the
header of received Caller ID
information.
Specifies the length of time
that the PBX waits before
attempting to detect Caller ID
information, after receiving a
call. To enable this setting,
Caller ID Detection Pattern
should be set to FSK.
Specifies the total time
required by the PBX to detect
Caller ID information.
Selects the DTMF code used
to detect the beginning of a
Caller ID series.
Selects the DTMF code used
to detect the beginning of a
Caller ID series.
Selects the DTMF code used
to detect the beginning of the
information segment of a Caller
ID series.
Selects the DTMF code used
to detect the end of a Caller ID
series.
Selects the type of the 3rd
header in a Caller ID signal.
2.4.1 PBX Configuration—[3-1] Trunk—Port
Description Input Type Note
Select
Select
Select
Radio
Radio
Radio
Select
Select
Select
Select
Select
Select
Radio
Programming Item List 39